Here’s a list of all the parts for my Prusa Mendel RepRap where I bought them and their costs.
- $95Stepper Motors x 5
http://www.alltronics.com/
I got the Nema 17 2A bipolar 4 wire connection stepper motor. Any bipolar 4, 6, 8 wire connection will work as long as the holding torque is greater than 3 kg*cm. If you’re unsure about what to get for yourself just go to ultimachine.com and get the ones there. You need 5 steppers because one axis uses two steppers and one stepper is needed to drive the PLA plastic feed. - $0Printed Plastic Parts
ebay
I actually got these parts from a friend, but you can order them from ebay. Search for “prusa” and get an SAE kit if you go with the same hardware store parts I did. THey should cost somewhere around $40 for just the plastic printed parts. - $96 x Bearings 608ZZ 8x22x7
http://www.amazon.com/
Get 6 608 bearings for your RepRap. Buying a few extra is a good idea. - $0Fans
Luckily I had a friend with a few 40 mm fans that I could have. You’ll need 3 or 4 of them. They are available from alltronics or ultimachine. - $30Power Supply
ebay
I got a 20 A 12 V power supply. Any power supply will work that has 12 V and at least 5 A or 15 A if you are going to run a hotpad. - $66PLA Plastic
- $60Hardware Store Odds and Ends
http://www.mcmaster.com/
A couple metal rods and belts that can’t be printed. - $200RAMP Complete Set Preassembled
http://ultimachine.com/content/ramps-pre-assembled-kit-complete
The RAMPS set is the guts of the Prusa, including the Arduino Mega microcontroller and the Pololu Stepper Motor Drivers - $86Hot End Extruder Kit
http://ultimachine.com/content/makergear-hot-end-kit-3mm-filament
I got the the 36 mm length .35 mm diameter with the wooden mounting pieces.
How about a picture or video of what you are building? (RepRap Prusa).