Getting the Parts For My New RepRap Prusa

Here’s a list of all the parts for my Prusa Mendel RepRap where I bought them and their costs.

  1. $95Stepper Motors x 5
    I got the Nema 17 2A bipolar 4 wire connection stepper motor. Any bipolar 4, 6, 8 wire connection will work as long as the holding torque is greater than 3 kg*cm. If you’re unsure about what to get for yourself just go to and get the ones there. You need 5 steppers because one axis uses two steppers and one stepper is needed to drive the PLA plastic feed.
  2. $0Printed Plastic Parts
    I actually got these parts from a friend, but you can order them from ebay. Search for “prusa” and get an SAE kit if you go with the same hardware store parts I did. THey should cost somewhere around $40 for just the plastic printed parts.
  3. $96 x Bearings 608ZZ 8x22x7
    Get 6 608 bearings for your RepRap. Buying a few extra is a good idea.
  4. $0Fans
    Luckily I had a friend with a few 40 mm fans that I could have. You’ll need 3 or 4 of them. They are available from alltronics or ultimachine.
  5. $30Power Supply
    I got a 20 A 12 V power supply. Any power supply will work that has 12 V and at least 5 A or 15 A if you are going to run a hotpad.
  6. $66PLA Plastic
  7. $60Hardware Store Odds and Ends
    A couple metal rods and belts that can’t be printed.
  8. $200RAMP Complete Set Preassembled
    The RAMPS set is the guts of the Prusa, including the Arduino Mega microcontroller and the Pololu Stepper Motor Drivers
  9. $86Hot End Extruder Kit
    I got the the 36 mm length .35 mm diameter with the wooden mounting pieces.
This entry was posted in 3D Printers, Uncategorized. Bookmark the permalink.

One Response to Getting the Parts For My New RepRap Prusa

  1. Z.K. says:

    How about a picture or video of what you are building? (RepRap Prusa).

Leave a Reply to Z.K. Cancel reply

Your email address will not be published. Required fields are marked *